Case along with official v2 camera, RP 3 B and 7 inch screen arrived yesterday. I spent a few hours trying to figure out why the case didn't fit. The RP board is attached to the screen as shown in the YouTube installation video of the case. Not as easy as I saw in the video Install the case, unscrew all but one screw holding the RP to the screen. The remaining one is behind the wall mount hole, leave the screw loose to move the RP so its peripherals fit the holes in the case. Now everything fits. Except the screen mounting hole is offset by about 2mm so I had to insert the screws at an angle to achieve alignment. To replace SD cards (which requires removing and unscrewing the PB each time) you need to change this configuration each time. Either that or manually attach the case to the wall, stand, etc. upside down.
Gikfun Screw Shield Expansion Board: Enhance Arduino UNO R3 with the EK7007 Add-On
11 Review
🌐 MCIGICM 2 Channel DC 5V Relay Module: Optocoupler Low Level Trigger Expansion Board for Arduino UNO R3, DSP, ARM, PIC, AVR, STM32, Raspberry Pi
11 Review
REXQualis Comprehensive Starter Kit with Arduino MEGA 2560 & Detailed Tutorial for Arduino IDE Compatibility
11 Review
🎁 Ultimate BBC Micro bit Sensor Starter Kit: Keyestudio 37-in-1 Box with Tutorial, Compatible with V1.5 & V2, Gift for Kids and Adults (Microbit Board Not Included)
11 Review
MacBook Retina 13-inch (A1425, A1502) and 🔩 15-inch (A1398) Bottom Case Screw Set with Pentalobe Screwdriver
11 Review
Comprehensive 500pcs Laptop Screw Kit Set for 🔩 IBM HP Dell Lenovo Samsung Sony Toshiba Gateway Acer
12 Review
36-Pack Black Rubber PC CPU/Case Fan Screws/Rivets Set for Computer
11 Review
M.2 Screw Kit: Easy Mounting for NVMe SSDs on ASUS Motherboards
19 Review