Review on 🎸 Position Guitar Toggle Switches by SALECOM by Ken Hamdan

Great little switch. There are two types of on/on/on switches: Make sure you have/need the configuration you think you will make. ;) Good workmanship (do not overheat!), great price, delivery on time. a full pass between the terminals, solder the first leg [exactly where the strip *ends*], then cut off the stripped/discarded insulation a bit [to leave room for solder on each end] and lay it down back onto the pre-stripped end protruding from the just soldered ferrule (easier with solid than with stranded wire), if necessary with a small shrink tube, then solder the other end of the "jumper" and simply cut off the excess. Solder to this small hole instead of two and there is no bare wire to short out. [Shrink tubing often only shrinks from the transferred soldering heat and only needs a hot air treatment for the "colder" end])