Review on Whiteside Surfacing Router Shank Cutting Tools for Spoilboard by Adolfo Goins

I have used this with a Woodpecker panel leveler. The bit was installed in my 3-1/4 PS router. at very low speed. The chisel worked well and cut quite cleanly throughout the process. I started slowly cutting less than 1/8 inch on each pass. In the end about 3/4 inch of the board was cut on both sides. The cutter shows no burn marks, but I suspect it's a little duller than when it started, which is to be expected with hard walnut wood. I would buy this blow again.