Like that, but previously applied Teflon pipe impregnation looks like cement. I got 1 engagement thread before I became uncomfortable applying more torque. I soaked dope in acetone for an hour and it softened. Hit it with a small flathead screwdriver to peel off the first layer and let soak for another hour. The rest was removed with a brass brush. I used regular teflon tape and got regular thread engagement. Pressure relief fittings have severe fitting size limitations. I see them running at 1/4 NPT where they don't release large amounts of pressure but when using them on a 100mm x 150mm pneumatic cylinder I feel they slow down the piston speed significantly and also make a lot of noise (would probably happen independently). Instead, I chose to use plastic tubing to reduce pressure drop and route it to minimize noise.
1 Inch Beduan Brass Electric Solenoid Valve, 12V Normally Closed Air Valve For Water, Gas, Fuel, And Oil
10 Review
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
13 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
6 Pack Miahart Adjustable 304 Stainless Steel 4 Inch Hose Clamp Duct 91Mm-114Mm Worm Gear Pipe Clamp For Automotive, Mechanical Agriculture.
18 Review