Review on 🌟 Top Quality PLA Filament Additive Manufacturing Product in 3D Printing Supplies by Darryl Blumenthal

I bought this Enotepad gray PETG filament to use for some prints that needed to be stronger than my regular PLA filament. I think I got exactly what I needed. Color wasn't a factor in my decision as the pieces I bought these for will eventually be colored but after printing this sample vase I like the shade of gray and will probably make a few pieces to add to my white fire pit for a fireplace to deliver. This thread is flexible yet strong and the layer adhesion is amazing. I ran the hot end of the printer at 245 degrees Celsius and the bed at 63 degrees Celsius. I set the layer thickness to 0.16 and I can barely see the layer lines. My printer shows a line pattern on the outer shell when I run it fast due to vibration, so I run it slowly, typically around 40mm/s. After tightening everything I will print the same vase again and see how it looks. So the Enotepad PETG 1.75 Gray Thread is on par with the more expensive brands I've tried. The roll didn't wind in perfectly straight lines, but I had no sticking and I had the minimal "squeezing" that always comes from PETG. Likewise. The coil was hermetically sealed with an oxygen absorber. This is a must for me. I'm glad I tried this brand. Try it.