Header banner
Revain logoHome Page
Ricky Pee photo
1 Level
791 Review
71 Karma

Review on ๐Ÿ–จ๏ธ Wanhao Photon EPAX Thickness-Optimized 3D Printer by Ricky Pee

Revainrating 5 out of 5

Better than original film in every way

Even though the name "non-FEP film" means it's probably a sheet of regular cling film, apart from the false advertising, the stuff definitely fits to them. should be purchased and kept on hand in case the original FEP film becomes damaged. It's pretty obvious that it releases prints better; I think maybe I mounted it too loose (you should put a plastic bottle cap or thin piece of styrofoam underneath when screwing it into the frame so it doesn't stretch too tight and get damaged when you then screw the frame into the tank for resin ) as I can hear it lift a bit with the model before it pops out between layers, but despite that all my prints are fine and this film hasn't shown any signs of damage yet other than a few small, shallow scratches (which I would also expect from FEP). The only reason I removed the star from the value is because of its static nature it is very easy to damage the sheet prior to installation z making it difficult to handle. I don't know if there is any real solution to this problem but it means your 3 packs can become 2 packs very quickly.

Pros
  • practical item
Cons
  • something different