Review on Efficient and Stylish Windemere 2 Handle Centerset Bathroom B2596LF for a Modern Upgrade by Corey Krull

The faucet looks good but there are a few quirks. The rod is bent and goes through the faucet body at an angle. You may need to install the rod through the faucet body before installing the faucet on the sink. This pusher controls all aspects of the faucet installation. I've never had a problem with a faucet depressor and I hate this design. But I finally got it working after a few tests. When the rod is pulled up to close the drain, the angle pushes the rod against the bulkhead, so the faucet should be mounted as close to the front of the faucet holes as possible. 2) The faucet isn't really designed to tilt over a shallow sink below. In other words, make sure the top of the sink is parallel to the bottom of the sink where the faucet holes go. I find this allows for a looser fit and the faucet can be rocked back and forth a bit. The top of my sink is slightly sloped while the bottom is flat. 3) The mixer is delivered without conical discs. I had a selection of cone washers and the ones that fit were the smallest. Make sure you have them on hand before you begin. If I wasn't so tired of lying on my back under the sink I would rip it out and return it. I'll keep an eye on it until the return deadline. This bathroom faucet was the hardest part to install on my sink.