Review on 🖨️ MakerBot MP07825EU Replicator 3D Printer: Unparalleled Printing Precision and Efficiency by Jason Dahlkemper

the thing prints everything as intended. That's the most important. The nice folks at MakerBot are pretty good at answering the phone, servicing people who seem to know what they're doing, and once they figure out the problem they arrange to send me a new one. Maybe they'll figure out why they're coming back and fix the problems, but until then they're very kind to replace whatever I have with a new unit. This unit is light years ahead of 2X ABS units in terms of pressure. Each print at 2x requires an hour of fiddling and setup, but with these devices you just send a print job and wait a while and then pick it up. . You must be on the same router to start printing, or most of the time but not always it says the printer is offline. The idea of having an Android app is a great idea, but after struggling with it for a while you just eventually give up using it. No matter how many times you define a printer in Android, after one or two uses you need to redefine the printer, which should be done physically on the printer and the device should be idle. My newer Samsung Tab S4 is not supported, but newer phones and older tablets are. don't intend to make any changes to the application or the list of supported devices." In other words, if you can get it to work, fine - if not, don't. Again, the printer prints great, except for the holidays , which you have to take every few months to replace with a new one.