Review on 🔧 Efficient Organization with TRUSCO 3 Cantilever Tray Tool Box GT-470-B by Patrick Hamilton

I love this tool chest, the only thing I could probably change is the dividers on the lower level because they scratch the paint when trying to put them in. Don't really like it, but then again it's a tool box. Love the fact that everything is made in Japan, even the wheels that come with the tool box are made in Japan and are really high quality. It rolls so easily that it makes no noise when it rolls or when you roll it. Unlike some tool boxes that have wheels made out of plastic, these wheels are made out of some sort of rubber and plastic. Very durable. Getting the wheels in is a little tricky, but if you have a chisel, preferably a cement chisel, you can pry up the bottom of the toolbox to set the wheels in place. A chisel and ball-point hammer did the trick. A few clicks here and there and the wheels are set. The tool box can also be closed in both directions, whether left or right. The dividers are big enough to fit a hand in and the top dividers (round) are adjustable but the bottom dividers (square) are not. So make sure when inserting they are really where they need to be, I only left them for facilities. Sake. The tool box is made from pressed steel so it will last quite a while and if it gets scratched just knock it out with a hammer and spray paint. It's quite heavy, but with wheels it's easier to move and lockable, there are no latches to break. If you have back problems this tool chest may not be for you, but if you want a quality and durable tool chest then this is the one for you. If for some reason water gets in, it will run down the sides. I slammed the lids several times to make sure it was really high quality and surprisingly it was! I may have damaged it, but overall it still closed left or right with no issues. Mine came dented on the corner, but I didn't mind because it gave it character.