The strut bolt broke when I tried to tighten it. I didn't put it on with much pressure either. It just came off like a soft piece of solder. It even broke when I tried to remove a piece of the motherboard with needle nose pliers. They appear to be made of very thin metal. Also, the plastic washers do not fit over the posts as shown in the picture. The hole is too small to fit the small collar at the top of the post. Because of this, you must install without a washer to ensure the washers are at the correct angle. And of course the discs can move without a washer.
Comprehensive 500pcs Laptop Screw Kit Set for π© IBM HP Dell Lenovo Samsung Sony Toshiba Gateway Acer
12 Review
MacBook Retina 13-inch (A1425, A1502) and π© 15-inch (A1398) Bottom Case Screw Set with Pentalobe Screwdriver
11 Review
M.2 Screw Kit: Easy Mounting for NVMe SSDs on ASUS Motherboards
19 Review
36-Pack Black Rubber PC CPU/Case Fan Screws/Rivets Set for Computer
11 Review
π UCTRONICS GPIO Breakout Kit for Raspberry Pi Pico - Assembled Pi T-Type Breakout + 830 Tie Points Solderless Breadboard + 40 Pin Male-Female-Male Rainbow Ribbon Cable + 65pcs Premium Jump Wires
10 Review
CZH-LABS Electronics-Salon Prototype Shield Kit for π οΈ Raspberry Pi - Ideal for Breadboard DIY Projects
13 Review
ZOTAC ZBOX-CI325NANO-U Series Nano Fan-Less Mini PC Intel N3160 Quad-Core CPU Silent Performance Barebone System SSD & RAM Not Included, No OS
12 Review
Complete Kuman Raspberry Pi 4B 3B+ Kit: Breadboard, Expansion Board, Jumper Cables, Ribbon Cable, Resistance Pack
9 Review