Well I recently installed my Uniseal with a 1.25 paddle bit and it's leaking. No, it's pouring. I'm not sure what went wrong, but it would be nice to get some advice on what type of glue to use to stop the leak. Any suggestions?
Upgrade Your Draft Beer Kegerator With The TerraBloom CO2 Keg Pressure Regulator - Dual Gauge Heavy Duty Unit With Safety Features
16 Review
1 Inch Beduan Brass Electric Solenoid Valve, 12V Normally Closed Air Valve For Water, Gas, Fuel, And Oil
10 Review
DIGITEN DC 12V 1/4" Inlet Feed Water Solenoid Valve Quick Connect N/C Normally Closed No Water Pressure
14 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
Flexaust 611S Polystyrene Cleaning Crevice: Versatile and Efficient Solution for Deep Cleaning
4 Review
Ultimate Performance: SpringSpray Aluminum Equipment Heavy Duty Industrial for Optimum Productivity
3 Review
Guardair 79SG012 Syphon Spray Gun
3 Review
π§ Thermoplastic Aluminum Fitting Equipment by SAFBY
3 Review