Review on πͺ Mophorn Hydraulic H-Frame Plates - 13,227 lbs Capacity by Carlos Macy
It's not strong enough for a bottle jack and a nominal weight of
The frame flexes when you use it on something too heavy to push down, and the press supports flex too easily. It did its job, but to use it again you have to replace the parts. I used it to pop out the U-joint on the outboard front axle of my Dodge. Screws were also missing due to holes in the box when it arrived. I had the right ones on hand and it saved me there.
- 6t.Capacity: stroke: 125mm, working width: 340mm. Capacity: 6t It is very useful and useful as a shop press. Strong enough to meet your needs.
- Not bad, but...
New products
Comments (0)
Top products in π Hydraulic Equipment
Another interesting products
Upgrade Your Draft Beer Kegerator With The TerraBloom CO2 Keg Pressure Regulator - Dual Gauge Heavy Duty Unit With Safety Features
16 Review
6 Pack Miahart Adjustable 304 Stainless Steel 4 Inch Hose Clamp Duct 91Mm-114Mm Worm Gear Pipe Clamp For Automotive, Mechanical Agriculture.
18 Review
DIGITEN DC 12V 1/4" Inlet Feed Water Solenoid Valve Quick Connect N/C Normally Closed No Water Pressure
14 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review