Review on 🚗 Custom 4-Pin Vehicle-Side Trailer Wiring Harness by CURT for Ford Explorer - Model 56172 by Darren Cole

, Yesterday I finally found the time to install these. It ran as expected and works with my car headlights and trailers on my 2015 Ford Explorer. However, I had two problems and it took longer than expected. I wish I had an elevator! First, it was difficult to disassemble the Ford fork. Lying on my back with mud falling on my face, I struggled to tear it apart. I ended up squeezing the little bracket as hard as I could and pulling as hard as I could and it popped. I then glued the matching ends into the Ford parts. There was a lot of exposed wire at this point, so I wrapped it in tape to protect it. It took some time. Next comes a small loop for a ground screw to screw into the metal. They provide a ground screw in the cable tie package. So you need to get a drill, drill a hole and screw it in. This also took time because there was not enough space. It was finally done. You then route the cable around the center of the hitch and secure it with zip ties. Try not to get near the silencer to avoid melting your skin. Note. The included zip ties are tiny and don't wrap around the clutch perch. I ended up using the ones I had. However, this matter is not so complicated. If I did the second, it would go much faster.