Review on 🧾 Optimized Kodiak Controls KC25-3 Pressure Gauge by Draven Invert

I needed this to make sure the system was holding the pressure. I only used 0.5lb and this thing was leaking so badly that at first I thought I'd have to rebuild all the lines I tested. Then I decided to check my setup and found that the pressure gauge was leaking really badly. In the end I sealed all the holes in the case with super glue and baking soda to speed up the installation time. It turned out that the sensor was almost completely covered in glue. I did my test but wasted a lot of time chasing the wrong leak for quite a while. I gave it two stars which was nice. Save your money if you don't have good troubleshooters. Money lost, but time is valuable too. PS Before this sensor there was a very good regulator, so it was protected.