Review on 🔄 Enhanced Performance: Standard Motor Products RY-1214 Turn Signal Relay by Josh Reynolds

Great for 1998 Ford Ranger. The factory flasher module has a 6 pin connector while the replacement module has a 5 pin connector - this doesn't seem to affect performance. Reach under the dashboard above and to the right of the hood latch. Slide the turn signal off the metal tab and pull down. There is enough tether in the wiring harness to pull the connector out from under the dash. Take a wide flathead screwdriver and pry up on the latch, then unplug the connector as needed. Install a new one and hide it under the dash. 3 minutes and a slotted screwdriver - flashing works great again. This turn signal is quieter than the factory turn signal, but otherwise it does its job.