Header banner
Revain logoHome Page
Jeremy Hahn photo
Georgia, Tbilisi
1 Level
696 Review
39 Karma

Review on ๐Ÿ”ง High-Quality VTEC Solenoid Spool Valve 15810-RAA-A03 - Perfect for Honda Vtec Accord CRV CR-V Civic Si Element Acura RSX by Jeremy Hahn

Revainrating 5 out of 5

Exactly as described

Received exactly what I ordered. For now. Replacement for a 2009 Honda C-rv 2.4L engine. The same part covers several years of publication. The same part can be used on a 2002 Honda C-rv ex with a 2.4 liter engine. Disconnect battery ground. Three screws removed, two harness connectors removed. Two of these wire attachments are still in place. Clean the contact surface. I actually want to make sure there's no dirt on it since it's a hard-to-reach stop on the back of the motor. So you will inevitably have to move it a bit when aligning a new part. Lubricate the seal and components before installation. Screws are not included with this item. You will either reuse the old screws or buy new ones separately. Hand tight first, then tighten to approximately 7 lbs. Reconnect the harness connector and fasteners. Replace ground on battery. Start the vehicle and perform an idle relearn. All accessories are turned off. start the car Increase engine speed and hold at 3000 rpm for 10 minutes. Set a timer. After ten minutes release the throttle and let the car idle for 5 minutes. When complete, turn off the vehicle and wait at least 30 seconds before restarting. And you run fine with a good idle around 7500 rpm. Happy Honda. No more high idle among other problems. Now it's decided. It can be installed from above or below, or you can remove the passenger wheel and drive through the wheel housing. Whatever you prefer.

Pros
  • 2 year manufacturer warranty
Cons
  • Can't remember