Review on 🔑 NHVWB1U711 Car Key Fob Keyless Entry Remote for Subaru Impreza 2005-2007, Forester 2005-2008, Baja 2006 by Adam Hardy

$60 for 2 replacement remotes - great deal since both work! The programming instructions posted on your website don't work, and by the way, the programming instructions in my Subaru's owner's manual don't work either. I've spent a lot of time on the internet looking for alternative guides and after trying a few different ones I finally found one that worked. Follow them closely and you'll be fine (although it took 2 tries to succeed) - the remote control has a small sticker with 8 numbers on it. Write them down on a piece of paper - make sure all the car doors are closed - open the driver's door, get in - open the driver's door fully, then close it - put the key in the ignition, turn the ignition 10 Turn on/off quickly (within 15 seconds). )- Open/close driver's door- Switch on ignition (do not start engine, just switch it on)- Use "Close/Unlock" button on the armrest of the driver's side door.- (Example : Say the first 3 digits on the Key fob stickers: 3, 2, 4) Click 3 times lock, then click unlock once, click lock 2 times, then click unlock once, click 4 times to "Lock". , then click "Unlock" once, and so on until you've dialed all 8 digits. - Repeat the entire 8-digit sequence of digits again, as described above - Take a new remote control and press the "Lock" and "Unlock" buttons once each - Open and close the driver's door fully - Pull the key from the ignition lock - fully open and close the driver's door - wait 5 seconds - now the remote control should work. I had to try twice for each remote before they worked. The part where you turn the ignition key 10 times within 15 seconds is critical. If you are too slow it won't work. With the right instructions, programming takes less than 2 minutes. Very happy with my purchase.