I would never admit that to any of the guys but: I've had times where I missed nitro soldering, only to pressure test and found a leak and had to redo it . Then fret and weld without nitro (shame). To explain. If you don't have such a thing, you'll need to set the regulator to <100psi, then remove the hose and attach the flow regulator to the bottom. to 3-6 psi, then make sure it is flowing properly, weld, remove the hose, remove the flow sensor, reconnect the hose and check the pressure again. Or you can click away from soldering to search for soldering. The whole company wants to switch to it. Bonus, it's less than your psi output and tank psi controls.
Vacuum cleaner Dreame V9 Global, white
145 Review
DIGITEN DC 12V 1/4" Inlet Feed Water Solenoid Valve Quick Connect N/C Normally Closed No Water Pressure
14 Review
1 Inch Beduan Brass Electric Solenoid Valve, 12V Normally Closed Air Valve For Water, Gas, Fuel, And Oil
10 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review