
This kit contains some inferior components. I bought it primarily as a crimping tool. The ports were a nice added bonus when I bought it (or so I thought). Crimping tool: In general, the crimping tool is fine. The cutting tool on it leaves a lot to be desired and some end up with sore hands after multiple uses. Wire Stripper: The wire stripper is pretty good. Connectors: They really suck. Of the 5 cables I ran, two were registered to the switch at 100Mbps. I had to redo them several times. In some cases they didn't snap properly and the connector fell off when I removed the wire from the crimping tool. Punch tool: I couldn't use the punch tool because the end point didn't match my sockets (cable is important, angled). Tester: I would say it's useless. On the above cables registered at 100 Mbit / s (not 1 Gbit / s), the tester lit up normally. new crimp tool. (There are only a few wires left to crimp.)

Cable Vention Jack 3.5 mm - 2xRCA (P550AC-S), 1.5 m, ice blue
6 Review

NOYAFA Underground Portable Detection Electrical: Unearthing Efficient Electrical Solutions
6 Review

Mastech MS6812 Telephone Tracker Network
9 Review

🔍 Klein Tools VDV501-852 Tester for Accurate Locating Abilities
3 Review

Portable Handheld Manometer 📏 for Accurate Pressure Differential Measurement
5 Review

🌬️ Advanced 3-in-1 Indoor Air Quality Monitor with CO2/RH/Temp Data Logging and Audible Alarm - NDIR Sensor Technology
8 Review

🌡️ Continuous Temperature Monitoring with Relative Humidity Integration
4 Review

🔥 Advanced Testo Wireless Hot Wire Anemometer Technology
4 Review