Review on ENEACRO SDS Plus Industrial Power & Hand Tools: Enhanced Vibration Control and Functionality by Josue Porter

At 5.5 kg it is not light, but it is ergonomic. Good functionality in terms of value for money. Pros: price, weight (approx. 5kg), grease cup on top, 2 SDS bits included, preloaded grease with grease refills included, tool case included, simple action with switches to switch to hammer-only mode/drill, thick plastic, manual included 2 spare sockets (under the motor), 1 year warranty and the gun fires with the plug with no problems or smell. High-quality steel bit holder. Ergonomics are top-notch with a low motor and large two-finger button with no security. (Security is disabled when not in use). Cons: Front grip is in the down position and must be unscrewed to adjust (with a screwdriver), no-impact manual in ft-lb, poorly articulated English but readable, included plastic-covered case - clips that seem to be a weak point ( Metal brackets on the body would have been better than the body's durability) and finally the pistol grip twisted a bit upon unboxing - I had to retighten all the bolts, as well as the motor nut socket wrench, as they were all slightly loose. The flex actually stopped after tightening (and the manual says to check/tighten the bolts regularly). There is no reverse gear (only $$$ has that effect anyway). No turning stop when releasing the button. (ie motor will slow down a few revs before stopping - again $$). Therefore, it should not be used as a faucet or coping. I knew this was happening - just FYI. Seems well made compared to the competitor, weight is good and heavy means no skimping on parts; at this price $109; this is a great buy. Seems solid, the N case is thick plastic and 2 bits for $10-15 each is a good selling point. Hopefully it will be years before I finish as I will be using it as a grinder, floor tile scraper and cement drill to place rebar into existing molds. I'm not a profi. 4.5/5 stars!