Review on Ducati Scrambler Fender Eliminator Kit: Plate Light Bracket by New Rage Cycles - Customize Your Ride! by Raymond Vogel

Installed it on my 2017 Scrambler Cafe Racer and the bike looks so much better. super easy. There is no need to splice wires as the license plate light and turn signals have a ready-to-connect wiring harness*. No hyper flash and no need to buy/use resistors. The turn signals are good and bright, but the license plate LED is not as bright as the stock one. I wish it was a little brighter but at least you can see what the sign says from a distance behind it so I shouldn't have any trouble with the police. * I only encountered two minor issues (but not deducting a star). First I had to bend down the pins in the NRC turn signal harness to fit the Ducati turn signal harness (nothing special but just in case you get stuck trying to push the harness in; it should be smooth and slick) . press once the pins are aligned) Second, two holes at the bottom of the board. You are supposed to screw them on with the existing hex screw holding the plastic bit [door] that hides the cables. However, it was difficult to line up all four holes after you bolted the top piece under the brake light. I was only able to align three of the four holes (even after slightly flexing and loosening the bolts that go under the brake). bright). To be honest I didn't put the hex bolt back in because there's enough pressure to hold the plastic in place and it never comes loose (it will make sense once you've installed it and seen it in person, trust me).