Review on 🖨️ SainSmart Enhanced Dimensional Additive Manufacturing Products with Superior Filament Toughness by Smiley Edwards

Update: 29 hour print at 175° has a lot of tension. I ordered black TECBEARS filament, which I know prints well and is cheaper, and it's going in the trash. Did a test print at the manufacturer's recommended 200° and noticed terrible stretching at every gap. So I lowered the temperature to my usual PLA temperature of 180° and the strings were still there, albeit much better. I had to lower the temperature to 175° to get a gapless print. The low temperature makes me wonder if it's PLA+ at all or just low quality PLA and makes me question the high temperature claims. Aside from the low temperature requirements, print quality was the same as other (cheaper) black PLA filaments.