Review on 🔒 Maximize Freshness and Extend Lifespan: ESUN 3D Printing Filament Vacuum Storage Bag by Todd Stovall

I live in Florida and I've always had issues with PLA+ becoming brittle over time and falling off the spool or when the printer was idle for too long all the filament in my teflon tube would split into 6-7 pieces when i used it again. I figured it was just because I was typing intermittently and he was getting old. I took my printer to the garage and the new spool of filament, which was nice and flexible, became brittle in less than 48 hours. I did some homework and figured it must be a moisture issue. After reading many conflicting reviews about different dry boxes, I bought this box (ebox lite version which is an upgrade of the regular ebox). Tossed in a thin spool of two 10g desiccant packs overnight while printing at heat level 1 and in the morning the filament was stronger and more flexible than when I took it out of the original pack. 100% recommended if you think you have a filament moisture issue.