Review on 🛴 8" Pneumatic Wheel for Kickscooter Scooter - Size 8x1 1/4, Aluminium Alloy Hub - 32mm Width, Inner Tube & Bearings Included by Josh Allred

I installed this on the front of an Oxelo Town 9 scooter that was converted to electric using a kit from the same seller. The wheel is thinner than the original polyurethane, however the installation is a direct replacement as the seller will provide the correct spacers. Riding is completely different than riding a polyurethane balance bike. I recommend if the surface you are riding on is not where you would think of skating even if you walk with your foot. The friction you get from a rubber wheel is about the same as riding a hard wheel over uneven ground. Because it's such a thin wheel, I figured it would pop easily. Recently I drove into a pothole (in the sidewalk) and hit my face. My scooter had a slightly bent frame and a small front axle, but the rim was undamaged and the rubber and airbox were intact. I think good quality. I take 1 star because I find the rim design ugly while all Oxelo rims look really nice and also because it would also look better if it was at least as thick as the original wheel. oxelo. It could even be a bit thicker and fit well on the fork.