when buying, I thought that everything would be fine - the parameters are very attractive (copper, a large basket and a 120 fan - well, very tempting). in fact, everything turned out to be just awful - the cat cried copper, a small patch, only in the center of the processor (where would a good heat sink come from then). the old boxed cooler was even more efficient. I looked at the temperature of the processor through (Aida 64) and with this system it was 3 degrees higher than with the standard cooler (just awful - unacceptable). began to look for a replacement and eventually settled on an analogue (good old - zalman) - ice hamer. I must say that this is really a good thing (all copper, plus manual speed control). if desired, you can of course polish the base to a mirror, but not necessarily. Measurements after installation, to put it mildly, struck me - under the same conditions, the temperature dropped by 14 degrees compared to (gamma archer pro). don't take this crap (gamma archer pro), better consider other options, even if a little more expensive, but they will be much more effective than this rubbish.
🚀 Enhance Your Vehicle's Performance with the Airaid 200-919 M.I.T. Modular Intake Tube.
9 Review
🔧 Improved Performance: K&N Cold Air Intake Kit for 2007-2009 FORD Mustang GT (63-2565)
9 Review
69 1018TS Performance Intake Kit
9 Review
🚀 K&N Cold Air Intake Kit: Boost Horsepower on 2015-2016 Ford F150 Turbo Ecoboost, 3.5L V6, 63-2592
9 Review