Review on 🐶 The Ultimate Comfort Solution: Introducing The Original Grip Puppy Comfort Grips! by Vincent Lott

I recently got a CTX 1300 with 7/8 inch grips. "I can't get used to these things. They seemed IMPOSSIBLE small and my hand cramped after just a short ride. I tried adding an anti-krumpster and even THAT didn't help because it tended to slip on ( mine seems too thin to me) Stock grips. I got them a week ago and it has changed the WORLD. Now the grips seem to be the normal width for normal sized hands, my grip heaters can still be felt through them, and the Crampbuster ( although largely unnecessary now) doesn't slip nearly as much. As far as I'm concerned, this is an absolute must if you're used to clunky grips. As for folks having installation issues, I can only speak of my own volition.The Handles are plain and tape wrapped around the handle where I had to cut it. Cut with a sharp knife. First I used the end I cut off to go to the bars go as it was a little rough oval. I rubbed some water mixed with dish soap on the inside of the grip pups and on the grips themselves. The CTX grips are rubber so I expected to have to work hard to put them on. It took less than a minute for each side. Slide them onto the bar's end weights, then simply twist and push. Voila, honestly, with very little effort. These things have saved me a lot of time and effort when it comes to changing grips on my bike. It looked like I would have had to sacrifice the grip warmers and put in some non-original grips to reduce the discomfort I was feeling. They took care of me and I didn't have to do without anything. An added bonus is the ease of installation. I'm a very lucky person. Keep the shiny side up boys!