Review on 📱 2017 Bolt EV Navigation: RUIYA Tempered Glass Protector - HD Clear Film for Eye Protection by Matt Bokil

I installed this screen protector today, this is how I did it. Simple instructions along with suction cup, alcohol pad, microfiber cleaning cloth, dust removal sticker and the protective film itself, repackaged for safety. A tab to remove the film from the side that should have been in contact with the display surface. I wiped the Bolt screen with an alcohol wipe and then dusted it off. Glue the suction cup in the middle to the outside and peel off the protective film. Centering the screen protector will leave a tiny gap on the screen, you will need that gap, trust me. My first attempt left a bubble under the screen and a missing speck of dust. At first I was a little panicked that I was stuck on this bubble because squeezing it with a microfiber cloth wouldn't work and it seemed impossible to remove the tempered glass screen even with such a gap. A quick YouTube video search found an elegant and simple solution, a piece of paper. An 8 1/2 x 11 sheet of paper folded in four easily fits in the corner of the display between the thick Bolt screen bezel and the angled edge of the protector. I managed to slip around the corner and slowly lift and separate the protective film from the screen. After I took it off I used the dust sticker to wipe away the dust particle and I tried again, this time it was better but a little crooked, the same technique lifted the protective film again and after a few more tries I finally had a great fit , no dust, no bubbles. The best I can tell you when installing one of these is to be patient, it will probably take a few tries to get it right. I've noticed that most of the reviews on these screen protectors are about bubbles and the like, it's not the manufacturer's fault, it's just part of the installation process. Much luck!