Review on OEMTOOLS 27032 Flange Type Axle Puller by Kevin Parker
However, after a little work with a dremel to remove excess cast, it stood up normally. Works as it should for pulling bearings
Tool worked as expected after a little work. Not suitable for Chevy 6-hole wheel. However, after a little work with a dremel to remove excess cast, it fits fine. Proceed as usual to pull out the bearing.
Pros
- Positive only
Cons
- Upgradeable
New products
Comments (0)
Top products in π§ Steering & Suspension Tools
OEMTOOLS 24429 Ford 3-Valve Spring Compressor: Efficient Tool for Ford Valve Spring Compression
3.78
9 Review
π§ Efficient Steering Neck Bearing Race Remover: OTC 4796 for Fast Removal
4.33
9 Review
π§ Dorman 614-030 CV Joint Boot Tool for Easy Installation
4.33
9 Review
Enhance Your Truck's Power with OrionMotorTech Heavy Removal Adapters
3.75
8 Review
