Review on 🔧 Enhanced Track Bar Bushing - MOOG K80777 by Scott Galloway

Purchased for Jeep XJ. I know it's not the right part. But I swapped out the stock rail for a Jeep that previously had a secondary cross member and already had a larger hole drilled in the axle mount. The standard screw and socket just didn't fit! The metal bushing had too much clearance for the 14mm bolt, so I used a slightly larger 9/16 grade 8 bolt and had to ream the bushing a bit. . The end result was a nice tight fit. I also had to grind both sides of the hub to match the length of the metal hub, after which it fitted nicely into the axle mount. Torque the bolt to approximately 120 ft/lbs. I think this will work great! It can also be a good solution if the holes in your axle mount are clogged and you want to try a larger bolt with a nice round hole.