Review on 🔧 PlasticWeld Plastic Repair Epoxy Putty by J-B Weld - 2 oz. by Bernardino Suazo

Worked very well. I used this to fix some broken mounting points in the laptop, it was hard work getting putty where I wanted it in such a small space, but once I got the first piece in place I just kept adding a thinner layer added it was built. and gently pressed, added as much as possible (in space) and then I made sure that when you reassemble the laptop you can still screw the tiny screws into the attachment point (1 wasn't aligned). I reopened the laptop as needed I made sure everything was fine and installed it. Once set up it was rock solid and fitted perfectly where needed, assembled the laptop, tightened everything up and has held up very well ever since. In the attached picture they are very close and look huge, each of these areas is less than half the size of your thumb. **NOTE If you mix it up after it's mixed well, make sure you scrape off any excess that's stuck to your fingers like you didn't. It might stay there for a while if you forget it lol.