Review on 🎮 Enhanced Retroflag SUPERPI CASE UCase NESPI CASE SNES Case with Power & Reset Buttons, Raspberry Pi Heatsink Fan, and Flannel Bag for RetroPie Raspberry Pi 3 B+ & Raspberry Pi 3/2 Model B/B+ by Troy Jennings

Case looks great and comes with this set for only $30! No complaints, fantastic value for money. The instructions leave a lot to be desired (e.g. remove the micro SD card before installation, there are 2 different sets of 4 screws each and it's not clear which one to use for the lower part of the case, the copper heatsink goes to the chip under the board, etc.). The screws cut into the plastic and I found that the front left side doesn't hold up well so the case doesn't close tightly and you can probably forget to open the case later. The stickers on the cartridge are bent, so they will peel off on their own after a few minutes. The eject button doesn't work for me unless I press down on the case behind the slot. And it's all up to me, but I broke the micro SD card, screwed in the circuit board and didn't realize it was supposed to come out first. This is my fault, but it would be nice to see this as a disclaimer in the instructions. To end on a positive note, the controller in this kit works well and is a great way to get started right away.