Header banner
Revain logoHome Page
Ben Jacobson photo
Finland, Helsinki
1 Level
706 Review
57 Karma

Review on πŸ”’ Efficiently Secure Plasterboard with Glarks Anchor Setting Assortment by Ben Jacobson

Revainrating 3 out of 5

Requires tool tuning

The center pin hole was drilled too far toward the back of the tool, limiting the stroke to .040". Replacing the pin with an 18-gauge bar increased travel to .144 inches. The anchors are poorly shaped compared to Fastenal or Hiltie. It is recommended to use JIS #2 bit instead of Phillips bit.

Pros
  • Basic Set
Cons
  • Blank