Review on Enhanced Rugged Ridge 11231.02 Euro Guard Kit for 07-18 Jeep Wrangler JK, Including Turn Signal and Side Marker Protection by Andy Hearshman

I bought these to add some spice to my 2010 Sport Unlimited Jeep Wrangler. I prefer burgundy black, so I buy enough black Rugged Ridge products. As mentioned, the front turn signal guards were a breeze to install. Climb up there and stick two clips in the light and they will slide straight ahead. My biggest concern was that they didn't seem to fully fit the stock lights. The two clips barely reached the grooves and I had to use needle nose pliers to crimp the two metal tabs to make sure they stayed. However, once this is done, they look fine once installed. As for the side fender flares, that's a LOT more work than it should have been. In fact, no tools are required aside from an allen wrench and lots of elbow grease! The worst thing about installing the fender side shields is making sure you don't break the little ridge holding the hood housing inside the fender. That's easier said than done. Take your time with this and take your time. After they're done, they look ok, but I think the turn signal guards have more impact. Overall, the installation took me about an hour and a half, but in reality it should have taken 30 minutes max. I'm not upset with the purchase, but I'm not thrilled either. If you use all Rugged Ridge products this can add a bit to the look, but if you "just" use them I'd say pass.