Review on Splash Guards Fender Flares Wrangler by Anthony Cayton
Instructions Primed and DRILLING REQUIRED
Drilling Required Front requires drilling a hole in the plastic inner fender. In the rear, the factory screw is not long enough to fit with the fender (screws not included), also in the rear there are no holes in the rear bumper, so 3 holes need to be drilled on each side. Plastic rivets are cheap, found 3 faulty ones, be sure to buy extra, in general it's not that bad, but the color is dark black, and the bottom is more gray.
- Exterior Accessory
- Zero
New products
Comments (0)
Top products in 🚗 Mud Flaps & Splash Guards
Another interesting products
Yokohama Ice Guard IG50 215/50 R17 99Q winter
36 Review
SuperJump Trampoline with SuperJump 8ft (244 cm) net and ladder
29 Review
4WD ORCISH Recovery Traction Boards Tracks Tire Ladder For Sand Snow Mud - Set Of 2 (2Nd Gen Bag + Mounting Pins, Black)
39 Review
Get Ultimate Towing Stability With CURT TruTrack Weight Distribution Hitch & Sway Control - Up To 10K Capacity, 2-Inch Shank & 2-5/16-Inch Ball - In Sleek Black Design
30 Review