Review on 💥 Enhanced Performance with SHINE SING UV Curing Standard Photopolymer: Unleash Vibrant Colors and Rapid Curing by Brent Henderson

Finally a resin that isn't as brittle as brittle peanuts! Feels MUCH more like ABS filaments. Best of all, it prints beautifully with a shorter exposure time, with crisp detail. I'm ordering another bottle of this tonight, I'm so impressed. I had this bottle of standard skin tones (non-water washable) on the shelf for about 3 months and finally found the time to use it and was blown away. The only thing that bothers me about printing with resin is the glassy brittleness of some other brand's resins. anycubic 2.0 washing and curing station. I've found that a strong UV cure of less than 5 minutes is best for an ABS-like feel. I tested this filament by leaving it in the sun for over 8 hours and it darkens VERY slightly (only 1%-2% darker, nothing major). The resin retains a slight but still slight ductility (like ABS plastic) and will not crack. This is by far my favorite (*cheap) resin. Defects? It's a little on the smelly side, but not by much. Its vapor isn't the worst of the resins I've tested, somewhere in between. Use in a ventilated place.