Review on Optimized UNIZ ZMUD 3D Printer Resin by David Silva

I have an Elegoo Mars 2 and this resin FAILS on EVERY PRINT! It can't even print the standard hook file. The print continues to fall off the build plate before the part is complete. I tried several build plates and the resin failed every time! Attached is a photo of FOUR FAULTS! To make matters worse, this test print takes 2 hours. And since this resin is not transparent, I have to wait an hour to find out that it failed! - EDIT - I've corrected a few typos in my review above and would like to give an update on this resin. I've found that this resin sticks to it when I sand/scratch the build plate. And he managed to print the standard tower pressure. But as it turns out now, Xavi's pylons failed. I've also found that when I combine this resin with other brands, it also sticks to the build plate. For example: I mixed this resin with some Elegoo Green Translusent resin and FINALLY got a good print. What is the picture of a dog. The combination of resins changed the color to flesh. Which I actually like better. I also found unmixed tower marks peeling off the layers at random spots. Unfortunately I threw them away before deciding to take photos. If you get this resin then I STRONGLY recommend skipping it with other resins. In itself it is short-lived and poorly printed. ::UPDATE CHANGE::It's been a few months since I've used this resin and had a successful print. I have found that it works much better when you combine it with other brands of resin. But this is not an update. The update is that these prints made exclusively with this resin are now self-dissolving. Cracks along the lines of the layers, as well as cracks along the entire perimeter. I've added new images of Hook's original prints to show what I mean. Avoid this resin until this problem is resolved. Images look brighter than they really are due to my phone's camera autocorrect. But the cracks are still very visible.