Review on 🔩 Screwdriver Attachment for Drilling with Degree Driver by Chris Long

I used a few different 90 degree impact wrench adapters. This one is about as good as any other considering you need three hands to use any of them. However, this has the advantage of being smaller than most. The first use was to drive sheet metal screws into a sheet metal heat shield over a gas water heater vent. I couldn't get the others I used there. The product appears to be well made. no burrs to snap his fingers the first time he spins out of control (due to the absence of the third hand). I gave 4 stars because the hex shank could be a bit longer. Overall a good device that I would buy again.