Review on 🔒 Yukon Gear & Axle YHC70006 Hardcore Locking Hub Set for GM/Ford 1/2 Ton & 3/4 Ton Truck Dana 44 Differential with 19-Spline – Enhancing SEO by Josh Cooper

Robust construction and good looks. I used the YHC70006 on a 19 Spline Dana 44 that came off a mid 80's Grand Wagoneer. I installed them myself and replaced a set of premium hubs which are rubbish compared to these Yukon hubs. The only small issue I had was that according to the instructions there is a snap ring at the end of the axle shaft, there is a spot in the instructions that says some applications cannot use this snap ring. Well, I didn't have enough room on the end of my axle to put a locking ring on, but I was worried I was doing something wrong. So I called the Yukon and they told me not to remove the locking ring. Their customer service is great, if you have any questions about any of their products give them a call and they will help you. After installing the hubs I took my Jeep for a ride and they did a great job. They lock and unlock easily with two fingers, no pliers are needed, and locking and unlocking takes just a quarter turn. I know these hubs cost more than most on the market but they are worth every penny. I am very satisfied with this wonderful product.