Review on 🛠️ Cabinet Knob/Pull Installation Template Guide - AN0251C-CL-U | Improved SEO by Steven Latham

I didn't actually use the allocated holes because they didn't match my doors. The drawer worked great, you just need to measure the center of each drawer, then line up the center hole with that mark and choose the height you want, hit the marks with an awl, drill the holes and install the hardware. Did a quick job with my entire kitchen and everything worked out perfectly. I marked the holes I used with a red marker so I don't get confused or make a mistake as the product has so many holes it's easy to get confused. I first measured and drilled the door without a piece. Once I knew one of them was perfect and had a hole, I placed the product on the door and drilled a hole in the back of the door (where I had already drilled) and went right through the product, creating a new hole right where i needed one. I then used this marker to mark the rest of the doors. Worked great. I wanted to make my own stencils out of wood, which would give me the same result, but it was less of a hassle. Great product if you know what you are doing. If you don't = double check all your marks before drilling and you can make pencil marks instead of an awl in case you get a little wrong. Much luck!