
Sockets wear out fairly quickly - they are lost. There is no need to connect and disconnect the same test block too many times. I reconfigured a lot on the same board. After a while, the socket no longer held firmly and I lost the electrical connection. If they feel lost, use a new board. They are not intended for permanent installation.

GeeekPi Raspberry Pi Cluster Case with Cooling Fan and Heatsink for Pi 4 Model B, 3 Model B+ & 3/2 Model B
11 Review

Vilros Raspberry Pi 4 4GB Complete Starter Kit - Black Fan-Cooled Aluminum Case for Heavy-Duty Performance
12 Review

π MCIGICM 2 Channel DC 5V Relay Module: Optocoupler Low Level Trigger Expansion Board for Arduino UNO R3, DSP, ARM, PIC, AVR, STM32, Raspberry Pi
11 Review

Gikfun Screw Shield Expansion Board: Enhance Arduino UNO R3 with the EK7007 Add-On
11 Review

π₯οΈ Helifouner 450-Piece Computer Standoffs Spacer Screws Kit: Ideal for Hard Drive, Motherboard, Fan, Power Graphics & Computer Cases
10 Review

MacBook Retina 13-inch (A1425, A1502) and π© 15-inch (A1398) Bottom Case Screw Set with Pentalobe Screwdriver
11 Review

uxcell 3.5" HDD Screw Black 200pcs for Computer PC Case - Flat Phillips Head - 6#-32 - Hard Drive Fasteners
10 Review

36-Pack Black Rubber PC CPU/Case Fan Screws/Rivets Set for Computer
11 Review