Header banner
Revain logoHome Page
Steve Walton photo
Viet Nam, Olathe
1 Level
679 Review
37 Karma

Review on Greartisan DC 12V 30RPM Gear Motor High Torque Electric Micro Speed Reduction Geared Motor Centric Output Shaft 37Mm Diameter Gearbox by Steve Walton

Revainrating 5 out of 5

Torge was right for my opinion

I setup this motor to rotate my bowls on the tailstock of my lathe so I could paint resin on them while turning. Lathe speed was way too fast at slowest speed so I built my own turner. 30 rpm had just the right amount of torqe to do the job. Motor runs for about 3 hrs while resin sets up.

img 1 attached to Greartisan DC 12V 30RPM Gear Motor High Torque Electric Micro Speed Reduction Geared Motor Centric Output Shaft 37Mm Diameter Gearbox review by Steve Walton

ο»Ώ

Pros
  • Motor as expected. No complaints. Good power and very slow RPM as desired.
Cons
  • Struggled to barely move a coolaroo blind with a 18v Dewalt drill battery. now I.just use the drill