I agree that paper was very difficult to put down at first. The rubber tabs were so stiff that it took a while to remove the packaging. The paper is held in place by three nails on each side, so not only can you lift the flaps a little, you have to lift them just enough for the paper to peel off the nails. I thought my first job would be impossible without four hands. However, after about a dozen uses, the rubber seems to have softened and now it's a little easier to lift the flaps and I've gotten used to the paper setting. a small block that is comfortable to work with, very low hand fatigue, especially compared to no block. Also the base is slightly flexible with little pressure; This came in handy for sharpening an old ax and probably other slightly curved tools. 1.4 sheets of paper are a perfect length (just make sure the first end is fully inserted) with a slight overhang in width.
USA Made Diamond Lapping Paste Polishing Compound 600 Grit Mesh 22-36 Microns For Rock Glass Metal Jewelry Resin Marble With High Concentration Of Diamond Powder By TechDiamondTools
30 Review
MAPORCH 2 Pack Steel Wool And Gap Blocker Set - 3.2”X7.5 Ft Control Fill Fabric And Brass Wool For Protection Against Animals, Wall Cracks, Vents, And Pipeline In Garden, House, And Garage
12 Review
🔆 Enhanced Superfine Assortment: Various Sizes, Multi-purpose, and Reusable
10 Review
Office chair Bureaucrat CH-1300N, upholstery: textile, color: black 3C11
14 Review