Review on 🚴 IronHorse Bicycles Bike Tracker by Mike Lunde

Just installed and taken for a short trip. Installed easily, worked the first time, instructions are clear and easy to understand. The display is large, clear and easy to read. I took it on a measured course and it seems pretty accurate. A very small mistake. When attaching the display bracket to the front and rear tubes on the handlebars, over-tightening the cable ties will deform the bracket, preventing the display from sliding onto the bracket. I loosened the straps a bit and the display finally turned on. Seems secure enough and not prone to slipping or twisting. December 2020 Edit: Yes, it worked fine for a while, but then it started working erratically. The cold aggravates the situation. I was on a drive today (45 degrees Fahrenheit) and while driving at 7.5 mph the gauge sometimes jumped up to 10 or 16 mph. Of course, this also falsifies the mileage. My standard 4 mile run was 4.93 miles. Yes, it has been calibrated and the batteries have recently been replaced. I've also tried using a magnet for sensors 1mm to 10mm apart, nothing improved the erratic behavior. Hello iron horse. How about you send me one that works? Time will tell, but so far my impressions are very, very good!