1 Level
1301 Review
75 Karma
Review on Niagara Cutter N59913 Finishing Non Center by James Nedumaran
Good sharp stain and seems to last a relatively long time
Good sharp stain and seems to last a relatively long time. I've found that if I increase the feed to 35mm/min it breaks! At 30 mm/min everything is fine.
Pros
- Milling Accessory
Cons
- old
New products
Comments (0)
Top products in π§ Milling Accessories
Autotoolhome High-Speed Steel Straight Cutter
3.88
7 Review
πͺ Sleek and Precise: SpeTool Carbide Chamfer Carving Chamfering for Clean Edges and Smooth Carving Surfaces
1.82
5 Review
πͺ AFUNTA 4-Flute 0.08" Milling Bits
3.31
7 Review
π§ SPEED TIGER Carbide Square Mill - Precision Tool for Enhanced SEO
3.59
7 Review
