Review on 🖨️ Aluminum Function Assembly Printing: 180X180X180mm Efficient Design by Hector Liamsi

Original review below but tired of trying to make it work. The nozzle began to ooze a thread from the part of the body it was screwed into. Leveling was still a nightmare. I'm sure I received a defective one, but I sent it back and chose a different brand. ----------- I'm going to use this more for useful detail, so not detailed, and it seems fine for that. I had a couple of big disappointments such as the adjustment screws weren't attached to the aluminum plate so just turned them with the knob as it turned. this was very difficult to fix and as a result had to abandon the magnetic sheet attached to the board, replace the screws, repair the screws and print new handles as the screws had different threads. I still wanted to do it to make them wider so they stick out of the bed a bit more. At the very least (and if you run into the same problem) I would just cut holes in the magnetic sheet right where the screw heads were, attach them and nap. UPDATE: Just send it back. I would recommend replacing the balance springs and supporting the horizontal rail when sagging. I replaced the standard mat with a glass mat. I would recommend either replacing the spring for the Z axis with a stop screw or cutting off a rigid tube or something else to use in its place as the screw wobbled even with the spring tight. Plan some work on it not only to make it better but also to learn how these things work if you are a beginner