Review on 🌪️ Makita Dust Extracting Nozzle, BSS610 - Enhance Dust Collection Efficiency with the Makita 419283-5 by Joe Roberts

After I went to Tacoma Screw to get a screw that should have been included, I used some Loctite to secure the screw. Little did I know that Loctite attacks the thermoplastic, damaging the bolt tongue. I removed the pieces from both saws I bought them for and glued them together. I use one of my saws to cut Hardie siding. I attached the spigot to this saw and felt that the 2" hose I attached to it would load it and probably pull it off the saw. So I decided to use my standard hot glue gun and glued it to the saw. For workplace use it has made it much stronger and I don't worry about makeup. I tried turning on the video which showed that it picks up a lot more dust than if the vacuum was not used. I'm going to drill a series of holes in the blade guard because when you retract it will block the exit hole in the blade guard. I usually wear a mask every time I cut Hardy, I just forgot to put it on for the video and still do even though vacuums are included.