Header banner
Revain logoHome Page
Elder Unogu photo
1 Level
1258 Review
31 Karma

Review on πŸ”© High-Quality 20 Black 12x1.5 Closed End Bulge Acorn Lug Nuts - Cone Seat - 19mm Hex by Elder Unogu

Revainrating 5 out of 5

very nice nuts. They have slight embossing on the side. Still beautifully done.

These nuts look very pretty. They are a one-piece construction, meaning they are all one piece. I bought these to replace the swivel nut. What's the difference, an integral type is just a single piece. or fixed. The cap design is a nut that looks more like a standard nut that is open at both ends but has a nice chrome cap at the top. The problem with this type of design is that over time dirt, corrosion, etc. can build up or get under this 'lid' and when it does the lid will sort of bulge out in the middle when pressed lid on. out. When this happens, it can cause you to not be able to pull the socket or socket out the way you want and possibly have trouble removing it. Mine are starting to do this and I can't even put the socket halfway on the nut because of it. This means they tend not to be striped or rounded on the outside. This type of design or solid design doesn't have that problem which is why I chose it. In terms of size, they were bought for a 2003 Stratus. They are I would say about 1/4 inch or so larger than the factory. Since they're a bit bigger, it doesn't hurt, I don't really care. bag and this bag was in the box they show. They also use a standard 19mm jack. Same size as my car. on them and outside of them. The finish is almost perfect. I say almost because the only mark in it is where the size is. They stamped the size on the side of the clamp nut itself. it's not very deep there and you don't even notice it from a distance, you only notice it up close, the embossing in it isn't very deep either, and this embossing is only on one side of the nut. There are no markings on 5 sides, personally I don't quite understand why they have these embossings on them, but still they look damn nicer than the ones on my car now. ds and they are very well carved. No rough edges and full thread depth. It went into the hairpin very easily and didn't stick at all. Overall I really can't say anything bad about them. Anyway, it would be nice if they sold them without the embossing on the side, but as it's slightly present and not very noticeable, especially from a distance, I won't complain too much. Since no one has posted actual photos of the lug nuts themselves and how they are stamped, I'm posting a few photos. I was a little concerned about this after someone gave them 2 stars for this. At the same time, I was hoping for the best, but I was expecting something that would look ten times worse than it actually is. At least now you can see the stigma and decide for yourself whether it bothers you or not. Me. no But that's my opinion. I hope the pictures help you. I posted 3 photos so you can see them better from different angles.

Pros
  • Absolutely amazing!
Cons
  • Not bad, but...