Review on White Ceramic Wall Mount Rectangle Sink With Chrome Faucet And Pop Up Drain P Trap (T02), 18-3/8" X 1.5 GPM, Eclife Bathroom by Seth Bushey

I first have to say I have not yet installed this sink. I’ll come back to comment on the actual job site installation. Some reviews have mentioned metric threads and fittings but the unit I received appears to have 1-1/4” p-trap and stop and waste fittings. Also these fittings are chromed brass including the faucet that came with the unit.Also some reviewers said no wall brackets were provided. I provided a photo with the type of wall mount hardware that came with the sink. No heavier than the sink is, they should be sufficient. However I would mount to studs rather than use the plastic anchors also provided.In addition some reviewers said no instructions were provided, welcome to the trades. I provided many photos of the "sequence of things”. Just remember rubber is the cushion between metal and porcelain and you will be fine. I could also anticipate someone may think pipe dope or tef tape will be needed somewhere. You do not need it. The supply lines going into the faucet have double "o” rings that prevent leaking. The "drain” pipes have rubber washers or compression washers at the slip joint nuts. Don’t muck up an otherwise clean install with pipe dope. Although the pop up flange has a rubber washer included with it, good practice would be to use plumbers putty around this fitting before putting it in the drain hole and tightening it all down.The product as a whole is from China. It seems to be of good quality and I think any competent plumber could install it, or any one who is handy.