Review on π HiLetgo ESP8285 Development Board V1.0.0 - 2pcs Set | 1MB Flash Lite, Wireless WiFi Internet Development Board by Keith Martin
Works with Tasmota and Ubuntu
As said in another review, it can be flashed with Tasmota. In this review, I happened to be using 8.1.0. Using the FT232 to USB Converter: Set the output power of the FT232 to 3.3VDC, connect the FT232 with 3.3VDC, GND, TX, RX to the board by connecting TX, RX on the board side Swap to make a crossover (TX-to-RX, RX) . -to-TX). To put the device into firmware mode, before connecting to the ground pin D3 (GPIO0) of the FT232 USB device, after connecting and applying power, remove the D3 jumper to ground for 5 seconds and run the firmware -command, e.g. B. so.sudo esptool --port /dev /ttyUSB0 write_flash -fs 1MB -fm dout 0x0 tasmota-8.1.0.bin When done, power cycle it, wait a while, connect to the new Tasmota Wifi hotspot "tasmota_XXXXXX-### #" and complete the setup. Enjoy
- A dream come true
- I have no real complaints about it, everything is fine
New products
Comments (0)
Top products in π₯οΈ. Single Board Computers
GeeekPi Raspberry Pi Cluster Case with Cooling Fan and Heatsink for Pi 4 Model B, 3 Model B+ & 3/2 Model B
11 Review
Gikfun Screw Shield Expansion Board: Enhance Arduino UNO R3 with the EK7007 Add-On
11 Review
LAFVIN Super Starter Kit for Arduino R3 Mega2560 Mega328 Nano with Detailed Tutorial - Compatible with Arduino IDE
11 Review
Vilros Raspberry Pi 4 4GB Complete Starter Kit - Black Fan-Cooled Aluminum Case for Heavy-Duty Performance
12 Review
Another interesting products
M.2 Screw Kit: Easy Mounting for NVMe SSDs on ASUS Motherboards
19 Review
π₯οΈ Helifouner 450-Piece Computer Standoffs Spacer Screws Kit: Ideal for Hard Drive, Motherboard, Fan, Power Graphics & Computer Cases
10 Review
Glarks 660 Pieces Phillips Assortment Motherboard
10 Review
uxcell 3.5" HDD Screw Black 200pcs for Computer PC Case - Flat Phillips Head - 6#-32 - Hard Drive Fasteners
10 Review