Review on 🖌️ Badger Air-Brush Co. SNR-403 Stynylrez, 4oz (1-Pack), Black by Carla Anderson

I've used most of the bottle now and all the while this stuff clogs the airbrush usually within the first few minutes of a session where I have to constantly disassemble and clean things refill. Remember this is a 0.3mm airbrush, not a small needle. With regular airbrush paint that I mix, I can dry a tank of paint in a matter of seconds. At first I thought it was due to particles in the primer due to poor storage or something similar. It's probably still a factor, but I don't think it's the full reason. I initially noticed that this material dries VERY quickly on the inside of the cup. It is, as if even a very small amount leaves a ring after only a few seconds. It finally dawned on me that this might be a factor - the primer was probably drying out in the middle of use and causing clogs. Finally I added a little more thinner, a flow improver and most importantly I think a bit of retarder. This made the material usable but of course had a big impact on the drying time as it has a retarder. I don't think I'll be using this primer again, but there aren't many options. some retarder. This made the material usable but of course had a big impact on the drying time as it has a retarder. I don't think I'll be using this primer again, but there aren't many options. some retarder. This made the material usable but of course had a big impact on the drying time as it has a retarder. I don't think I'll be using this primer again, but there aren't many options.